T/A 93 Evaporator Specifications

General
-Ducted air distribution
-Weight - 75 pounds (34 kg)
-Box Size - 34" x 24" x 14"
                   (864 x 610 x 356 cm)
-Cube - 6.6 ft³ (.19 m³)

Cooling Capacity
-Maximum capacity - 40,000 BTU/HR
                   (10,040 Kcal/HR)

Cover/ Ducting
 -Vinyl covered aluminum ducting with
                   upholstered head pad
--Multi-directional louvers
-Washable/reusable filter
-(2) 1/2 in. ID drain lines

Blower Assembly
-1 Blower assembly with (2) 4.5 in.
                   diameter blower wheels
-Amperage draw 11 A @ 13.5 vdc.
-Total CFM 800 ft.³/min (1,360
                    m³/HR) @ 0 static
-Double shafted, single speed,
                    permanent magnet motor

Evaporator Coil
-Face area 216 in.² (1,884 cm.²)
-Aluminum fins magnetically expanded onto 3/8" copper tubes, 4 rows deep by 10 high
-Fins: .006" thick, 12 per inch, corrugated surface, rippled edge
-Multi-tube distributor

Electrical
-Coded, stranded copper, Cross Link
-High and low pressure switches

Expansion Valve
-Commercial grade block type

Warranty
-(2) year, unlimited mileage limited warranty within the Continental US and Canada*

Capacities listed vary depending upon the rating conditions used.

Specifications subject to change without notice.

Note:  All measurements in standard (metric)

*Terms of Trans/Air's domestic and export warranty policies are available upon request.

Contact TRANS/AIR for more information.

Application
The T/A 93  has a maximum rating of 40,000 BTU/H and is designed specifically for small and midsized vehicles.  Typical applications include dual mounted evaporators for bodies up to 26 ft. in length.  With Trans/Air's Total Systems Approach, the T/A 93 evaporator can be used in conjunction with a wide variety of compressor/condensor options for a tailored system recommendation.

The T/A 93 evaporator comes standard with washable filter and padded head cover that can be upholstered to match the interior of the vehicle.  Multi-directional louvers supply full independent air flow throughout the cabin.  High efficiency over sized coils are standard for maximum cooling output and include a commercial grade block type expansion valve.

Blower assemblies come equipped with larger blower wheels for greater CFM and motors utilize custom wound armatures for lower amperage draw and greater efficiency.  Blower motors have permanent magnets and sealed bearings for longer life and fewer maintenance requirements.

Trans/Air controls provide precise regulation of airflow and temperature.  All wiring harnesses include coded wiring and are properly gauged for the system amperage load to minimize voltage drop and increase efficiency.  High and low pressure switches and a freeze stat are used to protect the integrity of the system.